How to Configuring the P2P Optical Fiber Access Service?

Point-to-point (P2P) optical access means the point-to-point FTTx access based on the combination between their P2P optical access board and the ONUs. So as to satisfy the users' requirements for the next generation access equipment which integrates video Voice, and data services.

Configuring the FTTH P2P Optical Fiber Access Service

Users connected to the OLT through an ONT, and are are provided with the Internet, VoIP, and IPTV service through a same port.

Service Requirements

• ONT_1 and ONT_2 are provided with the triple play service through FTTH .
• The Internet access service is provided in the PPPoE access mode.
• The IPTV users connected to ONT_1 can watch all the programs, and the IPTV user connected to ONT_2 can watch only program BTV-1.
• The VoIP service and the IPTV service are provided in the DHCP mode and obtain IP addresses from the DHCP server in the DHCP option-60 mode.
• After receiving different traffic streams, the OLT provides different QoS guarantees to the traffic layers according to the priorities of the traffic streams.
• Traffic streams are differentiated on the OLT by the user-side VLAN (C-VLAN).
  

Prerequisite

• The OLT is connected to the upper-layer devices such as the BRAS, multicast server, SoftX3000, and DHCP server.
• The VLAN of the LAN switch port connected to the OLT is the same as the upstream VLAN of the OLT.

Procedure

1, Configure the Internet access service on the OLT.

2, Configure the VoIP service on the OLT.

3, Configure the IPTV service on the OLT.

Result

After the related upstream device and downstream device are configured, the triple play service (Internet, VoIP, and IPTV services) is available.

The Internet user can access the Internet in the PPPoE mode.

The VoIP user can make and receive phone calls.

The IPTV user connected to port 0/5/2 can watch all the programs, and the IPTV user connected to port 0/5/3 can watch only program BTV-1.

Configuring MDUs Cascaded to an OLT

MDUs are cascaded to an Huawei MA5800 through the P2P board, derived savings upstream optical fibers and simplifying the network and service configuration.

Service Requirements

MDU_1 and MDU_2 are connected to an OLT through GE cascading, implementing the Internet access service.

The Internet access service is provided in the PPPoE dialing mode.

Procedure

Configure the OLT.

Configure the MDUs.

The configurations of MDU_1 and MDU_2 are the same. The configuration of MDU_1 is used as an example.

A. Create a VLAN and add an upstream port to the VLAN.

SmartAX MA5800 Multi-service Access Module

Feature Guide 4 P2P Optical Access

Issue 02 (2017-01-20) Huawei Proprietary and Confidential

Create smart SVLAN 200. The upstream port is port 0/0/1.

The security of the ASU is to be the same as the CVLAN of Huawei OLT. Huawei (config) #vlan 200 smart huawei (config) #port vlan 200 0/0 1

B. Configure a service port.

According to the actual conditions, an MDU supports multiple access modes. In this example, the Ethernet port 0/3/1 is used. For other access modes, see the corresponding configuration guide of the MDU. Huawei (config) # service-port Vlan 200 eth 0/3/1 multi-service user-vlan untagged rx-cttr 6 tx-cttr 6

C. Save the data. Huawei (config) #save